CyberData 011186 Uživatelský manuál stáhnout pdf (Strana 24)

Operations Guide 930796L CyberData Corporation

Installing the VoIP Outdoor Intercom

Intercom Setup

2.3.6.2 Restoring the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a

known state.

Note Each Intercom is delivered with factory set default values.

To restore the factory default settings:

1. Press and hold the RTFM button (see SW1 in Figure 2-11) for more than five seconds.

2. The device announces that it is restoring the factory default settings.

Note The device will use DHCP to obtain the new IP address (DHCP-assigned address or default

to 10.10.10.10 if a DHCP server is not present).

Figure 2-11. RTFM Button

2.3.7 Adjusting the Intercom Volume

You can adjust the Intercom volume through the SIP Volume, Multicast Volume, Ring Volume, and

Sensor Volume settings on the Device Configuration Page.

SW1

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Žádné komentáře

CyberData 011186 Uživatelský manuál Strana 24