
Installing the VoIP V3 Outdoor Intercom with Keypad
Intercom Setup
Operations Guide 930522C CyberData Corporation
34
2.4.6.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP Configuration page (Figure 2-15), make sure that the Register with a SIP Server
parameter is not selected.
Figure 2-15. SIP Configuration Page Set to Point-to-Point Mode
Intercom is set to NOT register with a SiP server
Komentáře k této Příručce