
Installing the VoIP V3 Outdoor Intercom with Keypad
Intercom Setup
Operations Guide 930522C CyberData Corporation
38
Call Button Enter the desired dial-out extension number (64 character
limit).
Note: For information about dial-out extension strings and
DTMF tones, see
Section 2.4.7.1, "Dial Out Extension
Strings and DTMF Tones (using rfc2833)".
Security Dial Mode
Enable Security Keypad Operation Select Enable Security Keypad Operation to put the
Intercom into Security Dial Mode. In Security Dial Mode,
the Intercom will act like a normal, one-button Intercom by
calling the extension specified in the Call Button field.
When a security code is entered on the keypad that
matches one of the seven-digit fields specified on the
page, the relay will be activated.
• This mode is meant for installation with security doors. In
Security Dial Mode, the Intercom will act like a normal,
one-button Intercom by calling the extension specified in
the Call Button field.
• Up to 10 (7-digit maximum) security codes can be
registered with the device. Enter a security code by
pressing the # key before entering the code. When one of
these codes is typed on the keypad, it will activate the
relay for the Relay Activation Timeout (in seconds)
setting.
• It is possible to enter a security code both inside and out
of calls.
• In this mode normal relay operation is suspended and
the following settings are non-operational:
Relay On Button Press,
Relay During Call Active
Relay During Ring
Relay During Night-ring
• In this mode, you can't send dtmf to a remote extension
using the keypad. You can however setup delayed dtmf
tones in the dial out string.
Relay Activation Timeout (in seconds) Type the desired length of time (in seconds) that you want
the relay to remain activated after a security code is
entered.
Play Tone While Relay is Active Check this box to play an audible tone while the relay is
activated.
Table 2-11. Button Configuration Parameters (continued)
Web Page Item Description
Komentáře k této Příručce