CyberData 010935 Specifikace stáhnout pdf (Strana 22)

CyberData Corporation 930181E Operations Guide

Installing the VoIP Intercom

Intercom Setup

2.2.6.2 Restoring the Factory Default Settings

To restore the factory default settings:

1. Complete the steps in Section 2.2.6.1, "Announcing the IP Address".

2. Press and hold the Call button for 10 seconds.

3. When you hear the announcement, release the Call button. The factory default settings are

restored, and the intercom will automatically restart.

2.2.6.3 Restore the Factory Default Settings

When troubleshooting configuration problems, it is sometimes convenient to restore the device to a

known state.

Each Intercom is delivered with factory set default values for the parameters indicated in Table 2-3.

Use the RTFM switch on the Intercom face to restore these parameters to the factory default settings.

Note When you use the RTFM switch, the factory default settings are restored for only the

parameters indicated in

Table 2-3. The other parameters in the current Intercom

configuration will remain unchanged.

To restore these parameters to the factory default settings:

Table 2-3. Factory Default Settings

Parameter Factory Default Setting

IP Addressing static

IP Address 192.168.3.10

Web Access Username admin

Web Access Password admin

Subnet Mask 255.255.255.0

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Žádné komentáře

CyberData 010935 Specifikace Strana 22