CyberData 010935 Specifikace stáhnout pdf (Strana 24)

Installing the VoIP Intercom

Intercom Setup

Operations Guide 930242AB CyberData Corporation

2.1.6 RTFM Button

GENERAL ALERT

Caution

Your intercom will have either an RTFM button or two jumper pins labeled JP11

on the circuit board. If your intercom does not have an RTFM button, use JP11

for IP address announcement and factory reset functions. Intercoms with JP11

jumper pins instead of an SW1 switch correspond to part numbers 010935A,

010935B, 010935C, 010935D, and 010935E. You will need a jumper shunt to

place over the JP11 jumper pins per the instructions below. Intercoms with an

RTFM button correspond to part number 010935F.

When the Intercom is operational and linked to the network, use the Reset Test Function

Management

(RTFM) button (see SW1 in Figure 2-8) or place a jumper shunt on the JP11 jumper

pins (see JP

11 in Figure 2-9) on the Intercom board to announce and confirm the Intercom's IP

Address and test the audio is working. Your intercom will

have an RTMF button or a JP11 jumper

but not both.

Note You must

do these tests prior to final assembly.

Figure 2-8. RTFM Button (SW1)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 92 93

Žádné komentáře

CyberData 010935 Specifikace Strana 24