CyberData 011214 Specifikace stáhnout pdf (Strana 15)

Installing the VoIP Outdoor Intercom with Keypad

Intercom Components

Operations Guide 930809M CyberData Corporation

2.2.1 Call Button and Indicator Light

2.2.1.1 Indicator Light Function

• Upon initial power or reset, the Call Button LED will illuminate.

• During network setup the Call Button LED will blink 10 times per second until the device can find

a network address. This can take from 5 to 60 seconds.

• When the software has finished initialization, the Call Button LED will blink twice.

• When a call is established (not just ringing), the Call Button LED will blink.

• On the Device Configuration Page, there is an option called Button and Keypad Lit when

Idle. This option sets the normal state for the indicator light. The indicator light will still blink

during initialization and calls.

• The indicator light flashes briefly at the beginning of RTFM mode.

Figure 2-2. Call Button and Indicator Light

2.2.2 Dialing from the Keypad

• See the Enable Telephone Operation setting in Section 2.4.6, "Configure the Button

Parameters".

Call button and indicator light

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 118 119

Žádné komentáře

CyberData 011214 Specifikace Strana 15